23
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Configure the Hardware in the Rack
May 2003
Configure the Hardware in the
Rack
Once the server complex hardware is installed, you must configure the 2 media servers, the
SNMP Modules in each UPS, and the SNMP Subagent in the Avaya Ethernet switch. The latter
two are to allow that equipment to send alarms (traps) to the media servers.
This section covers the following tasks:
• ‘‘Configure Media Server 1’’ on page 24
• ‘‘Connect Duplication Cables’’ on page 40
• ‘‘Configure Media Server 2’’ on page 41
• ‘‘Connect UPS Ethernet Cables to Ethernet Switch’’ on page 48
• ‘‘Configure the SNMP Modules in the UPSs’’ on page 49
• ‘‘Configure the SNMP Subagent in the Avaya Ethernet Switch (if used)’’ on page 53
Once the hardware is installed you must upgrade the software on the two media servers,
configure them, install the license and Avaya authentication files, and test the connectivity to
the customer’s network. You upgrade and configure the first media server, verify its operation,
then upgrade and configure the second media server and verify its operation.
To Next Page
Loading...
