268
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Installing and Wiring Telephone Power Supplies
May 2003
Using the P333T-PWR switch
The P333T-PWR Power over Ethernet Stackable Switch can be used to power 46xx series IP
telephones in addition to providing a 10/100 megabits per second Ethernet connection. The
switch can form part of a stack with the G700 Media Gateway or members of the P330
stackable switching system.
!
CAUTION:
The Avaya P333T-PWR switch does not contain any user-serviceable components inside.
Do not open the case.
!
CAUTION:
The P333T-PWR switch can be used only indoors and in a controlled environment.
The P333T-PWR switch has 24, 10/100 Base-T ports, each of which can supply up to 16.5 watts
using the internal power supply and operates on a 100–240 volts AC, 5.3 amperes, 50/60 hertz
power source with the option of using the 44~57 volts DC, 15 amperes to boost the InLine
power.
The P333T-PWR switch can be placed in a wiring closet or on a flat, stable surface like a desk.
Screws are provided for mounting in a standard 19-inch rack.
Connect the P333T-PWR switch
Power up—AC input
1 Insert the power cord into the power connector (BUPS or AC Power Supply) on the rear
of the unit. See ‘‘Connectors on the P333T-PWR switch’’ on page 268
.
Connectors on the P333T-PWR switch
2 Insert the other end of the power cord into a nonswitched electrical outlet or the
connector on the BUPS.
The unit powers up and performs a self-test procedure. The LEDs flash at regular
intervals after the self-test procedure is completed successfully.
Figure notes
1 BUPS connector 2 AC connector
scdlp333 KLC 082002
INPUT
Amax
Vin
44-57V 15A
BUPS
INPUT
1
2
To Next Page
Loading...
