Avaya S8700 - Connect an Analog Station or 2-Wire Digital Station

218
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Installing and Wiring Telephones
May 2003
400B2 Adapter Connecting to a Modular Plug
Connect an Analog Station or 2-Wire Digital
Station
This example is typical of the 2-wire digital stations (2420, 64xx, 302D), 2-wire analog stations
(2500), analog Central Office (CO) trunks, Direct Inward Dial (DID) trunks, and external
alarms. See ‘‘2500-Type Analog Telephone Wiring’’ on page 219
.
1 Choose a peripheral to connect (such as a 2-wire digital station).
2 Choose the port circuit pack to use and its carrier and slot number (from ‘‘Port Circuit
Pack and Telephone Pin Designations’’ on page 219). For example: TN2183 Analog
Line, Cabinet 1, Carrier C, Slot 1.
3 Choose a port circuit on the port circuit pack, for example port 3.
4 Install cross-connect jumpers to connect the pins from the 2-wire digital station to the
appropriate pins on the port circuit pack.
5 Administer using Administrator’s Guide for Avaya™ Communication Manager.
Figure notes
1 Flush-Mounted Information Outlet
2 Surface-Mounted Information Outlet
3 To Individual Power Unit
4 400B2 Adapter
5 To Telephone
6 Destination Service Access Point
(DSAP) Power Cord
r749428 KLC 060396