38
Migrating to an Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Configure Media Server 1
May 2003
Configure SNMP traps
NOTE:
Configure trap destinations only if the customer’s network administrator wants alarm
notification.
Refer to the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server for host names, IP addresses, and community strings assigned to the UPSs and Ethernet
switch. These are the same ones you configure on the SNMP module for the UPS and the
Ethernet switch.
1 Under SNMP click Configure Trap Destinations to administer the simple network
management protocol (SNMP).
2 Click Add to add new trap destinations and community strings.
To Next Page
Loading...
