Avaya S8700 - Verify Port Media Gateway Address Plugs

118
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
Verify Port Media Gateway Address Plugs
The address plug is a jumper field on port media gateways (J58890H) only. The address plug is
located on the far right hand side of the backplane, to the right of slot 00.
A group of six pins is labeled for the media gateway (carrier) jumper connections. Verify that
the address plug for each port carrier is in the correct location for that carrier. See ‘‘Port Media
Gateway Address Plug Location — Rear of Media Gateway’’ on page 118. The factory default
setting is “B” (callout 2).
Port Media Gateway Address Plug Location — Rear of Media Gateway
Figure notes
1 Address Plug (shown set to carrier D)
2 Carrier B Jumper Location (Default)
3 Carrier C Jumper Location
4 Right Edge of Backplane
5 Right Edge of Media Gateway
6 Backplane Slot 00
7 To Connector Panel
3
4
5
1
6
2
7
add_plug CJL 050906