Avaya S8700 - Page 12

12
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Contents
May 2003
Wire the 1146B2 Power Distribution Unit 262
Reset LEDs on Power Distribution Unit 263
1152A1 Mid-Span Power Distribution Unit 263
Important Safety Instructions 263
Using the 1152A1 PDU 264
Connect the 1152A1 PDU 264
Connect the Cables 265
P333T-PWR Power over Ethernet Stackable Switch 267
P333T-PWR switch Important Safety Instructions 267
Using the P333T-PWR switch 268
Connect the P333T-PWR switch 268
1151B1 and 1151B2 Power Supplies 269
Important Safety Instructions for 1151B1 and
1151B2 Power Supplies 270
Using 1151B1 and 1151B2 Power Supplies 270
Connect the 1151B1 or 1151B2 Power Supplies 271
• Completing the Installation Administration 272
Verify translations 272
Set daylight savings time rules 272
Set locations (if necessary) 273
Verify date and time 274
View alarms 275
Enable and disable Ethernet switch ports 276
Back up the media server to PCMCIA flashcard 277
View alarms 279
Set product ID 279
Add INADS phone numbers 280
Enable alarms to INADS via modem 280
Enable alarms to INADS via SNMP 281
Register the system 281
• Accessing the Avaya S8700 Media Server 282
Connecting to the Avaya S8700 Media Server directly 282
Connecting to the Avaya S8700 Media Server
remotely over the network 284
Connecting to the Avaya S8700 Media Server
remotely over a modem 284
Setting up a dial-up connection 284
Dialing up to the media server 285
Finding the active media server IP address 285