120
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
2 Align the mounting holes in the rear ground plate over the bottom screws in the top
media gateway. See ‘‘Rear Ground Plate and Front Plate or Media Gateway Clip — Side
View’’ on page 121.
3 Align the mounting holes in the ground plate with the four holes at the top of the media
gateway below the top media gateway. Slide the mounting plate down to seat on the
screws.
4 Check all Time Division Multiplexing (TDM) bus cables and the Inter- Cabinet Cables
(ICC) to be sure they are not pinched by the plates.
5 Repeat Steps 1-3 until the rear ground plates are installed between all stacked media
gateways.
6 Do not tighten the screws yet.
Rear Panel Screw Locations
Figure notes
1 Expansion Control Media Gateway A (No ground
plate is installed on an un-stacked media gateway)
2 Rear Ground Plate (attached between stacked
media gateways)
3 Port Media Gateway B
4 Screws to Loosen
2
1
3
4 4
rnd_plt CJL 030696
To Next Page
Loading...
