122
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
May 2003
Use the front ground plate instead of the media gateway clip to attach the media gateways to
each other. Use one front ground plate between two stacked media gateways.
1 At the front of the media gateways, align the holes in the top of the front ground plate
with the holes at the bottom of the upper media gateway, and insert the four screws. Do
not tighten the screws yet. See ‘‘Rear Ground Plate and Front Plate or Media Gateway
Clip — Side View’’ on page 121.
2 At the front of the media gateways, align the holes in the bottom of the front ground plate
with the holes at the top of the lower media gateway. Insert the four supplied #12-24 x
1/2-inch (1.27 cm) thread-forming screws. Do not tighten the screws yet.
3 Repeat Steps 1 and 2 until all stacked media gateways are fastened together.
4 Tighten all screws securely.
Rear Ground Plate and Front Plate or Media Gateway Clip — Side View
Figure notes
1 Front Ground Plate or Media Gateway Clip
2 Battery
3 Rear Ground Plate
3
2
1
grdpltec LJK 031096
To Next Page
Loading...
