AVL F-FEM-DDC User Manual

What you should know
12
F-FEM-DDC — User’s Guide
1.5 Purpose and Scope of this Documentation
Target group This documentation addresses commissioning engineers, test bed operators
and system administrators.
The F-FEM-DDC manual supports you in planning and installation as well in
your daily work at the test bed.
Requirements It assumes that you are familiar with:
 basic knowledge of electro engineering
 understanding of the structure and operation of the test bed
 basic knowledge of control technology
 characteristics of various sensors and actuators
 basic knowledge in the PUMA open system
Contents & Scope This manual documents the I/O components when using the F-FEM-DDC in a
test bed system and describes the hardware:
 Connector pin out,
 Mechanical and electrical requirements
 Connectable Sensor types
Naming The Module name F-FEM-DDC is coming from its I/O combination:
 F: Fast
 FEM: Front End Module
 D: DAC (analog output) channels
 D: DIO (digital input and output) channels
 C: Counter functions (with digital inputs).
AVL Secondary
literature
 F-FEM Parameterization
 Safety Manual
 PUMA Open Operator Interface
Fig. 2
Information
This documentation does not and cannot replace adequate training.
NOTICE
The installation (putting into operation) may only be executed by authorised AVL
personnel.
Information
Further abbreviations you will find in chapter Glossary of Terms and Abbrevia-
tions on page 81.

AVL F-FEM-DDC Specifications

General

Brand	AVL
Model	F-FEM-DDC
Category	Measuring Instruments
Language	English