AVL F-FEM-DDC - 3.4 Software Installation

86 pages

To Next Page

To Previous Page

Installation

F-FEM-DDC — User’s Guide

3.4 Software Installation

The firmware has already been installed.

The firmware necessary for operation can be loaded by the automation system

during the initialization phase (chapter FFDM in F-FEM Parameterization).

Main Page

Warnings and Safety Instructions3
Grouped Safety Messages5
Table of Contents7
What You Should Know11
Safety Instructions11
Warranty Seal11
Intended Application11
Product Specific Information11
Purpose and Scope of this Documentation12
Typographic Conventions13
We Want to Hear from You14
General15
Basic Information15
Performance Data15
Cascading16
Visualization17
Status LED at the Front Side17
Status LED at the Rear Side17
Seven Segment Display18
F-FEM-DDC Block Diagram19
Installation21
Scope of Supply21
Mechanical Installation21
Electrical Installation22
Power Cable Inlet22
Power Cable Module to Module23
IEEE1394 Wiring24
Cable Design24
Recommended Bus Topology25
About F-FEM Devices, Nodes, Cables and Repeaters25
Mechanical Layout of a Cable Routing26
Grounding and Shielding27
Grounding27
Shielding28
Software Installation29
Operation31
Analog Outputs31
Block Diagram32
Specification33
Voltage Output33
Current Output33
Analog Outputs, General34
Digital Inputs35
Block Diagram35
Specification36
Counter Inputs36
Block Diagram37
Spikefilter38
Specification39
Accuracy40
General about the Evaluation of Counter Signals40
Parameterization41
Mapping between Input Channel, Counter and Track41
Digital Outputs Relay42
Block Diagram43
Specification44
Digital Outputs Transistor44
Block Diagram45
Specification46
Frequency Outputs46
Signal Type: Freq47
Signal Type: PWM47
Specification47
Aging and Calibration48
General48
Procedure48
Pin Assignment49
Locations of Plug Connections49
Front View49
Back View49
Analog Outputs X150
Digital Inputs X4151
Digital Outputs Relay X51, X5252
Digital Outputs Transistor X53, X5453
Power Supply X17, X1854
Ieee1394 X19, X20, X2154
Jtag X2255
Options57
15 Pin D-SUB Plug for DIO57
D-SUB Connector with Screw Terminals58
Digital I/O Connection Box DCB60
Mounting the DCB63
Counter Signal Adapter "CSA-Connector64
Assembling65
Block Diagram66
Specification67
Parameterization69
Connecting an RS422 Sensor70
Connecting an Inductive Sensor71
Connecting an Analog Sensor and Using a Variable Threshold73
Using a Different Supply Voltage75
Cable Adapter for CSA to F-FEM-CNT or -CON76
Counter Signal Adapter Advanced77
Valve Connectors According to DIN 4365078
Technical Data79
Electrical, Mechanical and Environmental Specifications79
CE-Conformity79
Glossary of Terms and Abbreviations81
Index83

AVL F-FEM-DDC - 3.4 Software Installation

Table of Contents

Related product manuals