Avocent MERGEPOINT SP MANAGER User Manual

The first part of the command will establish an SSH session to the MergePoint SP manager. The
command is passed through to the service processor connected to the MergePoint SP manager.
The MergePoint SP manager will validate and execute the command.
For example, a command to open an SSH session to the MergePoint SP manager and execute
power on command may look like this:
ssh –t jsmith:MGP@172.30.19.122 poweron
Command Name Description
clearsel Clears the SP SEL.
devconsole Opens SoL for the SP.
nativeipoff
Revokes direct access to the service processor.
NOTE: This command is only supported on the MergePoint SP5x24/SP5x40
manager.
nativeipon
Configures the appliance to allow direct access to the service processor.
NOTE: This command is only supported on the MergePoint SP5x24/SP5x40
manager.
powercycle Turns off a target device that is turned on, then after 10 seconds turns it on again.
poweroff Turns the target device off.
poweron Turns the target device on.
powerstatus Shows the power status of the target device.
reset Restarts a target device that is turned on.
sel Views the SP SEL.
sensors Views the sensor status of a target device.
solhistory Displays the history of the console on the managed server.
solreplay Replays the history of the console on the managed server.
spconsole Accesses the command line on the service processor.
spconsole <action> Executes the specified action on the service processor, then exits.
Table 6.1: Supported Service Processor Commands
Chapter 6: Administration Tasks Not Performed in the Web Interface 107

Avocent MERGEPOINT SP MANAGER Specifications

General

Brand	Avocent
Model	MERGEPOINT SP MANAGER
Category	Network Hardware
Language	English