Managing servers on the side navigation bar
The /admin1/map1/nodemanagesvc1 target is for managing the servers on the side navigation
bar of MergePoint SP manager. The /admin1/map1 target is associated with
/admin1/map1/nodemanagesvc1 target. You can add a server and delete a server from the side
navigation bar. Supported commands are: create and delete.
To add a server to the side navigation bar:
Enter the create command with OtherIdentifyingInfo property: create system*
OtherIdentifyingInfo=”user,passwd,ip,alias,kg,databuf,sptype”
For example, to add server 172.26.25.64 with the username root and password calvin:
/admin1-> create system*
OtherIdentifyingInfo=”root,calvin,172.26.25.64,test,,0,3”
NOTE: The valid “sptype” value and the service processor type which it stands for are:
sptype = 1 means IPMI
sptype = 2 means iLO
sptype =3 means DRAC
sptype = 4 means HP IPMI
sptype = 6 means DRAC/MC
sptype = 7 means IBM BladeCenter
sptype = 8 means SPs which can only be access by the Telnet or SSH
sptype = 9 means ILOM
sptype = 10 means RSAII
sptype = 12 means HPBladeSystem
To set an unmanaged server as a managed server:
Enter the set command with OtherIdentifyingInfo property: set system[n]
OtherIdentifyingInfo=”user,passwd, ,alias,kg,databuf,sptype”
For example, to add server 172.26.26.16 with the username USERID and password PASSW0RD:
/admin1-> set system43 OtherIdentifyingInfo=”USERID,PASSW0RD, ,test,,0,7”
To delete a server from the side navigation bar:
Delete a managed server by entering delete followed by the /admin1/system[n] target.
/admin1-> delete system1
/admin1/system1 deleted
Managing group servers
The admin1/map1/hostgroup1 target is for grouping servers. You can create a group and
add/remove managed servers into an existing group. Supported commands are: create, set and
delete.
160 MergePoint® SP Manager Installer/User Guide