Avocent MERGEPOINT SP MANAGER User Manual

and eth1 can remain as is. The DHCP range must be set up to use addresses between
192.168.0.130 and above.
Or, if you want to use the entire range of 192.168.0.x, complete the following steps.
• Ensure eth0 and eth1 have an address outside of the 192.168.0.x range (typically eth0 will
have an address outside of this range). See Private Subnets on the MergePoint
SP5x24/SP5x40 Manager on page 24. Or, to check the eth0 and eth1 addresses on the
command line, use the ifconfig eth0 and ifconfigeth1 commands.
• Optional) As a best practice, set the appliance side IP address for the private subnet to
192.168.0.1. See Private Subnets on the MergePoint SP5x24/SP5x40 Manager on page 24.
• Set the subnet netmask to 255.255.255.0. See Configuring MergePoint SP5x00 manager
network settings on page 21 or Configuring MergePoint SP5x24/SP5x40 manager network
settings on page 22.
Appendices 199

Avocent MERGEPOINT SP MANAGER Specifications

General

Brand	Avocent
Model	MERGEPOINT SP MANAGER
Category	Network Hardware
Language	English