Barco DP2K-12C

15. Power input
15. POWER INPUT
About this chapter
This chapter describes the procedures to replace the power input components such as main switch, m ains filter, ...
WARNING: Always disconnect the power co rd from the loc al po wer net before start any service action on the
Mains Input of the projector.
Overview
• Introduction
• Getting access to the Mains Input components
• Replacement of the mains ON/OFF switch
• Replacement of the mains input filter
• Closing the Mains Input compartment
R5905043 DP2K-12C/11CX 19/02/2018 267