Barco DP2K-12C

17. Lamp power supply
17.4 Installation of th e LPS module
Necessary tools
• 6 x 120 mm flat sc rewdrive r.
• Torque wrench w ith a 10 mm hexagon s ocket.
How to install the LPS module
1. Slide the LPS module into its compartment as illustrated.
Image 17-9
Insert LPS module
2. Fasten the four captive screws of the LPS module.
Image 17-10
Fixate LPS module
3. Connect the pow er cables coming from the SP G m odule with the “LAMP O UT” soc kets of the L PS module as illustrated. Fasten
the nuts with a torque of 4Nm (2.95 lbf*ft).
Warning: Make sure to place the w ashe rs and cable eye in correct order upon the pin as illustrated. Alwa y s use a plain wash er
between the output pin and the cable eye.
L
N
P
W
E1
W
Image 17-11
Lamp out connection
P LPS output pin.
W Plain w asher.
L Lock washer.
E1 Ca b le eye from SPG m o dule .
E2 Cable eye from LPS unit.
NNut.
Warning: Respect the polarity of the socket and cables. Red marked cables with the “+” pin, black marked c ables with the “-”
pin.
R5905043 DP2K-12C/11CX 19/02/2018 289