5. Removal and installation of projector covers
5.12 Installation of the front cover
The input cover and the lens m ay not b e installed yet.
Necessary tools
Flat screw driver.
How to install the front cover of the projector?
1. Check if the front filter is present.
2. Ensure that no lens is mounted and that the input cov er is not ins talled.
3. Install the front cover of the projector doing the following:
a) first hook in the side of the front c over at the front filter,
b) then gently push the other s ide of the front cover into p osition,
c) ensure that the locking studs in the corners click into their receivers.
B
C
A
Image 5-23
Install front cover
4. Secure the front cover by locking the captive screw in the middle at the bottom of the front cover.
Image 5-24
Fasten front cover
5. Reinstall the rubber dust ring around the lens holder. See detail at the right of image 5-24.
90
R5905043 DP2K-12C/11CX 19/02/2018
To Next Page
Loading...
