BD BACTEC™ FX Instrument User’s Manual
30
Select to save changes. When the Enter Password window appears, select the blank
password field. Enter the Supervisor password with the onscreen keyboard, then select
ENTER, followed by OK.
2.4.2 Reports Configuration
Reports configuration enables you to set up printing and reports parameters. See Figure 2-5.
In a BD EpiCenter configuration, modifications made to the Reports configuration settings are used by
all instruments.
Printer Selection Window:
Printer
Select the arrow next to the blank field under Printer Selection to choose the system printer.
You can choose No Printer, Network Printer* (not available in BD EpiCenter configuration),
BD EpiCenter Printer, or USB Printer*. If you choose Network Printer, the IP field appears.
BD EpiCenter Printer appears only if the instrument is connected to a BD EpiCenter system.
It is the default selection in a BD EpiCenter configuration.
*For Vx Works instruments only.
IP (Address)
For a Network Printer*, enter the IP (Internet Protocol) address of the printer. The default IP
address is 192.168.2.150. This field does not appear if BD EpiCenter Printer is selected as the
printer.
*For Vx Works instruments only.
QC Auto Report Window:
Time
To set the time for the Maintenance QC Report (Section 5.4.9) to automatically print, select
Set. The default value is the current system date/time. Refer to Section 2.4.5 for instructions
on setting time.
Disable checkbox
To disable automatic printing of the QC Report, select the Disable checkbox. The default
setting is disabled (checked). The checkbox only disables automatic printing; the report can
still be printed by request from the Reports menu.
Save button
NOTE
Incompatible printer may cause system malfunction.
If your printer is not listed, contact BD.
To Next Page
Loading...
