Belden thinklogical SMP2 - SMP Appliance Technical Specifications; SMP Module;Client Technical Specifications

System Management Portfolio 2.0 Product Manual Rev. C, Feb. 2020
Page 17
Contents of launchchrome:
#!/bin/bash
while true
do
/usr/bin/chromium-browser --kiosk https://192.168.13.9:60090/osd.html?sname=OSD1
Done
Note: To undo this modification, log into the SMP Client through the Console Port.
Navigating the SMP Module and SMP Client Front Panel LCD
Main Menu
#Network Parameters
- Static IP Addr IP = 000.000.000.000
- Static Subnet Mask Subnet = 255.255.255.000
- Static Gateway Addr GW = 000.000.000.000
- DHCP Mode DHCP = DISABLED
#System Parameters
- Card Type Type = 0xFD
-FPGA Rev. Rev = 0001.00.04
- Software Rev. Rev = 6
-Serial Number S/N = 10-190212
- FPGA Temp. in C 39
- Board temp. in C 38
- Low Speed connected No
- Local Ctrl Name Name = OSD-01
-Remote Ctrl. Name Name = Not Found
-Load Factory Defaults Yes/No = No
#SFP1 Parameters
- SFP1 Vendor Mfg = FINISAR CORP
- SFP1 Part Number P/N = FTLF8528P3BNV
- SFP1 Wavelength WL = 850
- SFP1 TX Power TX Power = 0.467mW
-SFP1 RX Power RX Power = 0.002mW
-SFP1 TX Bias Bias = 7.318uA
#Alarms
- SFP1 Loss Of Signal On
- Chassis Error Off
- System Reboot Off
- Configuration Changed Off
- Remote Heartbeat Lost On
- High Temperature Alarm Off
- Clear Alarms No
SMP_MC06