EasyManua.ls Logo

Belden thinklogical SMP2 - Safety and Product Information; Note and Warning Symbols; Class 1 Laser Safety

Belden thinklogical SMP2
79 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Management Portfolio 2.0 Product Manual Rev. C, Feb. 2020
Page 5
Note and Warning Symbols
Throughout this document, you will notice certain symbols that bring your attention to important
information. These are Notes and Warnings. Examples are shown below.
Note: Important Notes appear in blue text preceded by a yellow exclamation point
symbol, as shown here.
A note is meant to call the reader’s attention to helpful information at a point in the text that is relevant
to the subject being discussed.
Warning! All Warnings appear in red text, followed by blue text, and preceded by a red
stop sign, as shown here.
A warning is meant to call the reader’s attention to critical information at a point in the text that is
relevant to the subject being discussed.
Class 1 Laser Information
Thinklogical
®
products are designed and identified as
Class 1 LASER products.
This means the maximum
permissible exposure (MPE) cannot be exceeded when viewing the laser with the naked eye or with the aid
of typical magnifying optics (e.g. telescope or microscope).
CLASS 1 LASERS do not require any special
precautions under conditions of normal use.
SFP
Modules
Fiber-Optic
Cables
Class 1 Lasers

Table of Contents