Enter a Name and an IP address for the added Touchpanel, then click on OK.
The new Touchpanel will appear in the USERS / KBDS window (1). Select the desired SRCS-- ,
DSTS – and MACROS— to connect to the new Touchpanel (2). Select COMBI under START
PAGE (3). Click SAVE (4).
Note: After adding the touchpanel to your USERS tab, make sure to also select COMBI in
the START PAGE row in the USER DETAIL section. Otherwise the touchpanel will be blank
when it is powered up. (See the touchpanel manual Manual_Touch_Panels.pdf for installation
information.)
To Next Page
Loading...