540
6
CONTROL STATION
Studio ti 03312 540-04usa
101
Taking control phases
−
Set the control heads to the central idle position. The station cannot
take over the control with heads in different positions. You hear the
acoustic sequence of initialization.
−
Press CONTROL/SET. The CONTROL LEDs light up green steadily,
to indicate that the station has taken over the control and that the
operator is engaging the idle control.
−
Start the engine while you send the idle run control. If the levers of the
handles block are not placed on idle run, the interlocking start switch
will prevent the engines start.
−
Shift the levers on the forward or backward retainer. The gearbox
starts and the CONTROL LEDs light up steady red to indicate that the
operator is engaging either the ahead or the astern gear. For further
information, see the Manufacturer’s Manual.
j
WARNING
The next shifting of the handle will engage the speed.
To Next Page
Loading...