540
8
PROPULSION SYSTEMS
Studio ti 03312 540-04usa
149
For further information, see the Manufacturer’s Manual.
Oil filter Replacement Remove the oil filter case with proper wrench.
Open the oil filter with a proper cutter. Separate the fins and check for the presence of metal
slags in the filter. An excessive quantity of slags inside oil filter may lead to premature wear
of the filter or to a failure.
Clean the seal surface of the filter mounting seat. Make sure to remove the old seal
completely.
Apply clean oil to new seal.
Fit the oil filter and tighten until the seal comes in contact with the seat.
Tighten the filter by hand according to the instruction on the same. Do not overtighten the
oil filter.
Fuel filter Replacement Remove old fuel filter. Clean the sealing surface of the seal at fuel filter seat. Make sure that
all old seals have been removed. Apply clean fuel to new seal.
Fit the new fuel filter. Turn the oil filter on its seat until the seal comes in contact with the
seat. Refer to rotation scales on the filters as a reference for a correct tightening. Tighten
the filter further 3/4 of turn by hand. Do not overtighten.
Item Maintenance Notes and precautions
To Next Page
Loading...