540
8
PROPULSION SYSTEMS
Studio ti 03312 540-04usa
151
j
WARNING
If the temperature controllers are not replaced regularly, the engines
can experience serious damage. Do not start the engines if the
temperature controllers are not installed. If a temperature controller is
not fit correctly, the engine can overheat, damaging the cylinder heads.
Make sure that the new temperature controller is fit into original
position. For replacement procedure of temperature controller, refer to
service manual or address to your dealer.
j
WARNING
If only the temperature controllers are replaced, drain the coolant from
the system until the level of the liquid drained is below the controller
housing. Once the controllers have been installed, fill the engine with
coolant up to proper level. Make sure to fill with proper coolant. Keep
coolant to proper concentration.
j
WARNING
The engine should not run without air filter. Do not run the engine if the
air filter is damaged. Do not use elements with fins, gaskets or seals
damaged. Dirt penetrating inside of the engine may cause premature
wear or damage the components. The filter elements prevent the
penetration of air particles through the air inlet.
j
WARNING
Do not service air filter when engine is running: dirt may penetrate
inside of engine.
j
WARNING
Do not use transmission liquid, engine oil, diesel fuel or other lubes to
lubricate the air filter element. If improper lubricant is used, the element
could not operate correctly. Do not start the engine if the air filter
element is dry. Without oil the filter element could fail.
j
WARNING
Do not use compressed air, open flames or warm air to clean the air
filter element. Excessive heat restricts the cotton fiber and compressed
air can pierce the material. Let the element dry to the air.
j
WARNING
Do not use gasoline, steam or lye-based dissolvers, detergents or
solvents for the cleaning. Do not use compressed water or air to clean
the air filter element. Anyone of these liquids or methods could damage
the element.
To Next Page
Loading...