540
PROPULSION SYSTEMS
Studio ti 03312 540-04usa
152
8
j
WARNING
If the engine is started when the oil level exceeds the reference “FULL”,
this can cause the immersion of the drive shaft in the oil. The air bubbles
generated reduce the oil lubrication features and cause consequently a
loss of power.
j
WARNING
At each engine oil change, replace the oil filter too.
j
WARNING
The oil filters are produced according to manufacturer’s requirements.
The use of a filter not recommended by manufacturer could damage the
engine seriously as well as its bearings and drive shaft etc. This is
because particles of slag penetrate inside of the engine lubrication
system. Use oil filters exclusively recommended by the manufacturer.
S
CAUTION
The fuel spilled on hot surfaces or electric components may cause a
fire. To avoid possible injuries, disconnect the starter switch when fuel
filters or water/fuel separator elements are replaced. Clean fuel leaks
immediately.
j
WARNING
No dirt should penetrate into the fuel system. Clean the area around the
component of the fuel system to be disassembled, accurately. Cover all
disassembled components of the fuel system properly.
j
WARNING
Collect the fuel spilled into a suitable container. Clean fuel leaks
immediately.
To Next Page
Loading...