EasyManua.ls Logo

Bertram 540 - Page 190

Default Icon
392 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
540
HYDRAULIC SYSTEMS
Studio ti 03312 540-04usa
190
9
S
CAUTION
The fresh water circuit, and particularly the tank, must be cleaned
periodically by pouring in the case a specified disinfectant solution. We
do not recommend to drink the water supplied by the onboard system.
S
CAUTION
When the yacht is left unguarded for a long period of time, the pump and
water heater must be disconnected by means of the relevant circuit
breakers.
S
CAUTION
In yachts equipped with direct connection to shore fresh water the
maximum operation pressure should not exceed 29 PSI/2 bar and the
pipes must be disconnected during periods of unattendance for safety
reasons. Notwithstanding the presence of a, pressure switch, check the
pressure on the pressure gauge installed on the switch.
S
CAUTION
Periodically carry out inspection of the fresh water circuit and of the
bilges to find out the possible presence of leaks.
Repair leaks by releasing the pressure in the system, in order to avoid
damages to the furniture and to the electric devices.
S
CAUTION
The intake plug carries the indication “WATER” to avoid accidental
introduction of different liquids.
To avoid damages to the system and tanks, we recommend to
replenish by liquid fall and not by pressure.
j
WARNING
It is a good rule to optimize the use of water, especially if you are during
high sea navigation.
j
WARNING
When leaving the vessel unattended, the dockside fresh water supply
should be disconnected to prevent flooding the bilges in the event of a
broken pipe.
S
CAUTION
Before refilling the fresh water tank, check that fresh water supplied by
the shore system is drinkable.

Table of Contents

Related product manuals