To Next PageTo Next PageWhat to do if gas concentration is too low in Binder CB 160?
If the gas concentration (CO or O) in your BINDER Laboratory Equipment is too low, check that the doors are properly closed and that the door gaskets are not defective (replace if necessary). Also, ensure the gas cylinder is connected correctly, not empty, and opened. Finally, inspect the tube system for dirt accumulation or obstruction, clean or replace it.
Essential safety guidelines for installation and operation of the CO2 incubator.
Safety precautions for handling CO2, O2, and N2 gases within the chamber.
Guidelines for the safe handling, storage, and transport of gas cylinders.
Defines the intended applications and limitations of the CO2 incubator.
Description of the microprocessor controller T4.12 and its interface.
Procedures for unpacking and verifying the incubator and its accessories.
Instructions for safely moving and transporting the chamber.
Requirements for the installation site and environmental conditions.
Step-by-step guide for connecting the O2 sensor to the incubator.
General safety precautions and instructions for connecting gas supplies.
Guidelines for connecting the incubator to the power supply.
Overview of the default preset parameters for the chamber.
Explanation of the 'control off' and 'fixed value' operating modes.
Manage O2 control and associated pressure alarms based on gas requirements.
How the chamber behaves and recovers following a power interruption.
Important considerations and safety notes when setting high gas concentrations.
Step-by-step guide for setting parameters using the quick menu.
Procedure for acknowledging and silencing active alarms via the controller.
Description of the primary safety device protecting against overtemperature.
Details the electronic safety controller for preventing excessive temperatures.
Procedures for setting the safety controller's mode and setpoint.
Guidelines for minimizing contamination during incubator operation and maintenance.
Procedures and recommended agents for cleaning the incubator's surfaces.
Methods for chemical disinfection of the chamber in case of hazardous contamination.
Detailed process for performing the hot-air sterilization cycle.
Recommended maintenance schedule and service contact information.
General troubleshooting advice and common issues.
Troubleshooting specific problems related to the chamber's heating system.
Diagnosing and resolving issues related to low gas cylinder pressure.
Troubleshooting problems with CO2 and O2 concentration control.
Addressing issues encountered during or after the sterilization process.
Troubleshooting issues with the chamber controller and keypad.
Comprehensive table of technical specifications for the CB series chambers.
General| Interior Volume | 160 L |
|---|---|
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Number of Shelves | 2 |
| APT.line™ Preheating Chamber Technology | Yes |
| Natural Convection | Yes |
| Display | LED |
| Interior Material | Stainless steel |
| Exterior Material | Powder-coated steel |
| Door | Solid door |
| Controller Type | Microprocessor |
| Safety Features | Temperature limiter |
