114 Biodex Medical Systems, Inc. © 2017
12. Maintenance
The Biodex Balance System requires only the most basic general maintenance, performed on
an as-needed basis at least every three to four months.
Cleaning Instructions
With the system turned OFF, wipe down all surfaces except for the monitor/display with a
damp cloth. Mild soap and water can be used to remove stains and scuff marks. As needed,
inspect all locking and adjustment mechanisms for signs of wear or damage.
If there are any questions or further assistance is required, contact the Biodex Customer Service
Department.
General Maintenance Procedures
Lubricate the Following Parts with White Lithium Grease:
● spring assemblies.
● push plates (8).
● acme threaded rods.
NOTE: When checking for lubrication, it may only be necessary to re-distribute the existing
grease.
CAUTION: Some steps of these procedures require the Balance System to be
turned ON. When this is the case, use extreme caution working on the system.
ATTENTION: Certaines étapes de la présente marche à suivre nécessitent que le
système d’équili- brage soit mis SOUS TENSION. En pareille circonstance, user de
précautions extrêmes dans la maniplation du système.
To Next Page
Loading...
