Balance System SD (with v4.X software) 37
13. To stop the training session at any time, press <Stop> on the display. The system will stop
gathering data and the platform will return to the locked position.
14. When the training screen has been reviewed, touch <Print Results> to print the results of the
session, or <Save Results> to save the training session. If a patient identifier was not
entered at the start of the session (i.e., a name or an ID number), it must be entered now in
order to save the results of the session.
15. After printing or reviewing the screen, press <Start> to immediately begin another training
session using the same parameters, or press <Back> to return to the Patient Setup screen.
Maze Control Training
This mode allows the patient to follow a set pattern of movement throughout a maze in both
static and dynamic environments. Three skill levels allow the maze to be modified to create a
simple or more difficult environment through which the patient must navigate. Change the
platform from static mode to dynamic mode to facilitate progression.
To Access the Maze Control Training Mode:
1. Position the support handles and the display height and tilt for patient comfort.
2. At the Main Menu, touch <Training>.
3. Touch <Maze Control>. The Patient Setup Information screen is displayed. If this is a new
patient and the training session is to be saved after its completion, the patient’s name and
height must be entered. If the training session does not need to be saved, designate a
height value, which is correlated to the software’s scoring algorithm based on the calculated
Center of Gravity.
4. Touch <Test Options> to advance to the Maze Control Training Options screen if desired.
Here, the total time for the exercise can be set, initial and ending platform stability settings
can be entered, and the Display Tracing, Display Cursor, and Scoring Tone can be turned on
or off.
Figure 6.8. The Maze Control Training Options Screen.
To Next Page
Loading...
