84 Biodex Medical Systems, Inc. © 2017
Facility Information: Use this screen to enter information about the facility; reports can be
configured to show facility details.
Enable Tone: Touch this checkbox to be able to hear audio biofeedback when testing or training
with the device.
Enable Advanced Data Input Mode: Touch this checkbox to input a patient’s exact date of birth
and height numbers in the Patient Setup screen (as opposed to designating an Age number and
Height range; see Figure 5.2b)
Require Patient ID# for Patient Record: Touch this checkbox to require users to input a specific
Patient ID# for each new patient that in training or testing sessions.
Enable ‘Additional Information’ on Patient Setup: Touch this checkbox to enable the Additional
Info icon at the bottom of the Patient Setup screen.
Enable Vibro Tactile feedback: If the Biodex VibroTactile™ System was purchased to use with
the Balance System SD, check this box.
Enable Impairment %: Touch this checkbox to input a G-code impairment percentage number
for patients with Stored Test Results.
Print Facility Information on Reports: Touch this checkbox to input information about the
particular facility that will be displayed on printed reports.
Create, Save, and Recall Custom Protocols
Custom training and testing protocols can be created and edited in the System Utilities. Once
created, the protocols can be accessed from the main Training and Testing menus. (In both
cases, the <Custom Protocol> button is in the bottom center of the menu.)
To Create a New Protocol:
1. At the main screen, touch <Utilities>.
2. At the System Utilities screen, touch <Configuration>.
3. Select <Balance System SD Configuration> from the Configuration screen submenu.
4. Select <Custom Protocol List> from the Balance System SD Configuration submenu.
5. The Custom Protocol list is displayed.
6. Select <Add Protocol>.
To Next Page
Loading...
