Safety and Legal Information
To avoid injury to an operator the safety precaution given bellow, and throughout the
manual, must be strictly adhered to, whenever the equipment is operated. Only ad-
vanced user can use the instrument.
Bio-Logic SAS accepts no responsibility for accidents or damages resulting from any
failure to comply with this precaution.
Intended use of the equipment
The BCS-8xx series is intended for electrical control and measurements. It should be
used for no other purpose.
The BCSC-6U&12U and the BCSC-24U&38U cabinets with the BCS-PDU (Power
Distribution Unit) have been designed for exclusive use with the BCS series modules.
The BCSC-6U, 12U, 24U&38U cabinets are electrical laboratory equipment intended
for use by professionals and in laboratories, commercial and light-industrial
environments (indoor). Instrumentation and accessories shall not be connected to
humans.
Instructions for use
To avoid injury to an operator the safety precautions given below and throughout the
manual must be strictly adhered to whenever the equipment is operated. Only
advanced users may use the instrument.
Bio-Logic SAS accepts no liability for accidents or damage resulting from any failure
to comply with these precautions.
Grounding
WARNING!
The instrument should be connected to the safety ground (Protective Earth).
The continuity of the ground connection should be checked periodically.
Any interruption of the Protective Earth (PE) conductor outside the instrument could
result in personal injury.
Use only the IEC320-C13 power cords which have been supplied with the instrument
and designed for the appropriate current rating and including a protective earth
conductor.
Atmosphere and Temperature
- Do not operate in an Explosive Atmosphere
- Ensure that the ventilation grids are not obstructed on the front and rear sides of the
BCS-8xx series. An external cleaning of the air filter can be performed with a Vacuum
cleaner if necessary (see Maintenance chapter), to prevent excess ambient
temperature (The equipment produces heat), please consult our specialists to
discuss the best location in your lab for the instrument (avoid small &closed spaces).
To Next Page
Loading...