BONFIGLIOLI Vectron ACTIVE CUBE - Error Message

8.1.3 Error message
Encoding of error messages in response data set PWE-Low/Low-Byte in byte 7 (Slave 
Master):
Error no. (decimal)
according to
PROFIDRIVE
Meaning
0
non-permissible parameter number PNU
1
Parameter value cannot be edited
2
lower or upper parameter value limit exceeded
3
faulty data set
4
no data set switchable parameter
5
wrong data type
18
other error
20
system bus does not respond
Extension
Meaning
101
Parameter cannot be read:
103
Error when reading EEPROM
104
Error when writing EEPROM
105
EEPROM checksum error occurred
106
Parameter must not be written in operation
107
Values of data sets are different
108
Unknown order
Error number “20” may have different causes.
•
If you do not use System Bus: Check if the low byte is “0” (zero). With values greater
than zero, an attempt is made
to address a System Bus client instead of the
PROFINET client.
• If you use System Bus (e.g. via an EM-SYS module), the addressed device is not r
e-
sponding. Check if the addressed device is connected to power supply and the Sy
s-
tem Bus node addresses in the index low byte and in the parameter settings of
the
device to be addressed correspond to one another.
10/13 CM-PROFINET 31