9-10
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual Comms Programming
1) Using Solution Link call the paneland let the phone
ring no more than 4 times before hanging up.
2) Wait a minimum of 8 seconds (but no more than 60
seconds) before calling the panel again. This time
the panel will answer the incoming call as soon as it
registers the rst ring and the connection will be
established.
Answer Incoming Call Only If Armed
Setting this option will prevent the panel from answering
an incoming call unless at least one area on the system
is armed. If all areas are o the panel will not answer the
call. This option would be useful in a busy oce when
due to the large volume of incomming calls answering
machine bypass may not be eective.
Tone Bypass
It is often dicult to establish a remote connection to
a panel if the customer picks up the phone or if a fax or
answering machine answers the call before the panel
does.
While the ultimate solution to this problem is the use the
CLI Intelliconnect method, this requires the customer to
enable CLI via their telco provider.
When enabled, the new Tone Bypass option (MENU 5-3-4)
tells the panel to listen to every answered call and to look
for a specic sequence of DTMF tones.
The tone sequence will be sent by the remote programming
software and when the panel recognises them, it will
immediately seize the line away from the answering party
and the programming session will commence.
Remote Program Editing Only When Disarmed
Setting this option will prevent a Solution Link RAS
connection to the panel while any are is armed.
Allow ‘User Functions’ Via Remote Access Software
Setting this option allows access to user functions via
the RAS upload/download software. If this option is not
programmed, user functions will be disabled.
Report RAS Start / End Sessions
Setting this option will cause the panel to report the start
and end of RAS programming sessions in the history log
and SMS reporting messages.
Comms > Remote Access > L535
DTMF Options
MENU 5-3-5
1 DTMF Arming Y
2 DTMF Disarming N
3 DTMF User Functions N
4 DTMF Quick Arm ([0] + [#]) Y
5 Reserved N
6 Reserved N
7 Reserved N
8 Reserved N
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [3] + [5] + [OK]. The keypad will display
the current DTMF options.
-Bit-
1 4
3) Use the numeric keys [1] to [8] to toggle on or o
the option required.
4) Repeat Step 3 until all options are programmed as
required, then press [OK] to save and exit or press
[MENU] to exit without saving.
DTMF Arming
Setting this option enables user to remotely arm one
or more areas on the panel using their PIN and a touch
tone phone. This option requires the Solution Interactive
Voice module to be tted.
DTMF Disarming
Setting this option enables users to remotely disarm
one or more areas on the panel using their PIN and a
touch tone telephone. This option requires the Solution
Interactive Voice module to be tted.
DTMF User Functions
Setting this option enables access to user DTMF
functions using their PIN and a touch tone telephone.
This option requires the Solution Interactive Voice
module to be tted.
DTMF Quick Arm
Setting this option allows users and control room
operators to remotely arm the system using a touch tone
phone without the need for a PIN.
To arm the system call the number which the panel is
connected to and when the panel answer you will here
3 beeps in accending frequency if the panel is in the
disarmed condition. Press [0] + [#] to arm. You will hear 3
beeps in decending order when the panel arms.
To Next Page
Loading...
