Bosch Solution 16i - Page 102

9-12
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
Comms > Remote Access > L536
Voice Access Code

MENU 5-3-6
9 #
This option sets a 2 digit code which is used to access the
panel from any internal phone connected to the same
telco line as the panel. For this option to work, a CM100
Voice Module must be connected to the panel.
This default number may need to be changed depending
on the country and or telco exchange / PABX system
being used. Make sure that when the code is entered, no
external phone services are selected or activated. If they
are, then change the code to something else.
It is important to realise that this code is only used to start
the connection process. Once a connection is established,
the voice module will ask the user to enter their PIN before
they will be able to control the panel. The Voice Access
Code is shared by all users who need this type of access to
the panel. See the CM100 documention for more details.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [3] + [6] + [OK]. The keypad will display
the current voice access code.
qH
3) Using the numeric keys [0] to [9] enter the new
Voice Access Code then press [OK] to save and exit
or press [MENU] to exit without saving.
Comms > Remote Access > L537
CLI Number

MENU 5-3-7
First
Number
1 Digits 32
Second
Number
1 Digits 32
Third
Number
1 Digits 32
CLI Numbers (Call Line Identication) allows the Solution
control panel to answer an incoming call only when the
control panel identies that the incoming call is from any
one of the three CLI numbers programmed. Up to three
dierent CLI telephone numbers can be programmed,
each having a maximum of 32 digits.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [3] + [7] + [OK]. The keypad will prompt
you to edit CLI number 1.
cLi1 ?
3) Press [OK] to edit CLI number 1.
_
4) Using the numeric keys, enter all the digits for CLI
number 1. You can change a single digit by
scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
5) Press [OK] to save CLI number 1.
6) The keypad will now prompt you tp program CLI
number 2.
cLi2 ?
7) Press [OK] to edit CLI number 2.
_
8) Using the numeric keys, enter all the digits for CLI
number 2. You can change a single digit by
scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
9) Press [OK] to save CLI number 2.
10) The keypad will now prompt you tp program CLI
number 3.
cLi3 ?
11) Press [OK] to edit CLI number 3.
_