Bosch Solution 16i - Page 122

10-10
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Device Programming
Devices > Ethernet > L664
Encryption Key

MENU 6-6-4
1 Digits 32
0 0 0 0 0 0 0 0 0 0 0 0 0
i
Note
This feature requires rmware version 2.10 or higher.
The encryption key must match the encryption key on the
base station receiver for communication to take place. To
remove encryption, set MENU 6-6-4 as all zero’s.
1) Enter your Installer PIN + [MENU].
2) Enter [6] + [6] + [4] + [OK]. The keypad will display
the rst 6 digits of the current encryption key.
000000
3) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 32 digitencryption key, then press
[OK] to save and exit or press [MENU] to exit
without saving.
Devices > Ethernet > L665
IPRS Address (Reserved)

-

MENU 6-6-5
1 Digits 12
2 0 2 1 2 9 0 8 3 0 5 8
i
Note
This feature requires rmware version 2.10 or higher.
This menu is reserved for factory use. Do not change
unless requested to do so.
1) Enter your Installer PIN + [MENU].
2) Enter [6] + [6] + [5] + [OK]. The keypad will display
the rst 6 digits of the current IPRS address.
202129
3) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 12 digit IPRS address, then press
[OK] to save and exit or press [MENU] to exit
without saving.
Devices > Ethernet > L666
IPRS Port (Reserved)

MENU 6-6-6
0 7 7 0 3
i
Note
This feature requires rmware version 2.10 or higher.
This menu is reserved for factory use. Do not change
unless requested to do so. This menu must be 5 digits set
with the range of 0 to 65535.
1) Enter your Installer PIN + [MENU].
2) Enter [6] + [6] + [6] + [OK]. The keypad will display
the current IPRS port.
07703
3) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 32 digitencryption key, then press
[OK] to save and exit or press [MENU] to exit
without saving.
Devices > Ethernet > L667
Connetix NNC

MENU 6-6-7
0 0 0 0 0 0 0 0
i
Note
This feature requires rmware version 2.10 or higher.
The NCC number is used to prevent anti-replay attacks
when reporting in Connetix format. The NNC number will
be assigned by the control room at the time the account
is setup. Like the account number, the NNC will always be
unique.
1) Enter your Installer PIN + [MENU].
2) Enter [6] + [6] + [7] + [OK]. The keypad will display
the rst 6 digits of the current NNC number.
000000
3) Use the numeric keys [0] to [9] + [←] and [→] keys
to program the 8 digit NNC number, then press
[OK] to save and exit or press [MENU] to exit
without saving.