Bosch Solution 16i Installation Manual

11-9
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  System Programming
Report LAN + Current Overload
Setting this option will cause the panel to send an
Overcurrent Trouble report to the base station when the
current load on the LAN+ terminal exceeds its maximum
rating of 1Amp.
H OR N S P EA KE R OP TI ON S
System > Siren > L740
Tone

MENU 7-4-0
This menu allows you to customise the tone that is
emitted from the horn speaker when a non-re alarm is
triggered. By changing the tone and speed, it is possible
to program a unique siren sound for each system when
you are installing a number of them in close proximity to
each other.
1) Enter the Installer PIN + [MENU].
2) Enter [7] + [4] + [0]. The keypad will display the
current siren tone.
typ=4
3) Use the up and down arrow keys to change the the
siren tone.
4) Repeat Step 3 and 3 until the desired siren tone is
achieved then press [OK] to save and exit, or press
[MENU] to exit without saving.
i
Note
Only outputs programmed as Event Type 46 and or
47 will be aected by this menu option.
System > Siren > L741
Speed

MENU 7-4-1
This menu allows you to customise the speed of the siren
tone when a non-re alarm is triggered. By changing the
tone and speed, it is possible to program a unique siren
sound for each system when you are installing a number
of them in close proximity to each other.
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [4] + [1] + [OK]. The keypad will display
the current siren speed.
SPd=09
3) Use the up and down arrow keys to change the
siren speed.
4) Repeat Step 3 until the desired siren tone is
achieved then press [OK] to save and exit, or press
[MENU] to exit without saving.
i
Note
Only outputs programmed as event type 36 and or
37 will be aected by this menu option.
System > Siren > L742
Volume (RF SPK Beep)

MENU 7-4-2
(*** System Wide Parameter ***)
1 5
This menu allows you to program the volume level of the
radio key speeker beeps which are heard when the system
is armed and disarmed using a radio keyfob.
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [4] + [2] + [OK]. The keypad will display
the current siren volume (default = 15).
d= 15
3) Using the numeric keys, enter the new volume
level. Valid entries are 0 to 15 where 15 = the
loudest volume and 0 = no speeker beeps.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
i
Note
Only outputs programmed as Event Type 36, horn
speaker with beeps will be eected by this menu
option.
System > Siren > L743
Siren Swinger

MENU 7-4-3
(*** System Wide Parameter ***)
0 3
This menu allows you to program how many times a zone
programmed for Lockout Siren can sound the siren during
each arming cycle.
At default, zones programmed for Lockout Siren will be
able to trigger the siren 3 times before being locked out.
The count will be reset when the system or area is next
disarmed.
1) Enter your Installer PIN + [MENU].
2) Enter [7] + [4] + [3] + [OK]. The keypad will display
the current Swinger Siren count.
d= 03

Bosch Solution 16i Specifications

General

Brand	Bosch
Model	Solution 16i
Category	Security System
Language	English