5-11
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual Access Programming
-Bit-
1 2
5) Repeat Step 4 until all Reader options are
programmed as required, then press [OK] to save
and exit or press [MENU] to exit without saving.
All On Arming Allowed
Selecting this option allows the prox reader to arm the
area that it is assigned to when a valid token is presented.
The User must have access to the Area that the Reader
has been assigned to. See MENU 1-6-1 — Reader Area
Assignment
Disarming Allowed
Selecting this option allows the prox reader to disarm the
area that it is assigned when a valid token is presented.
The User must have access to the Area that the Reader
has been assigned to. See MENU 1-6-1 — Reader Area
Assignment.
Badging Required
Selecting this option allows the user to unlock a door
and arm an Area from a single reader. This option is only
relevant if Arming Allowed has been selected.
When the area is disarmed, presenting the Token once
will unlock the door. Presenting the Token 3 times within
5 seconds will arm the Area.
When the area is armed, presenting the Token once will
disarm the area. Presenting the Token a second time will
unlock the door.
Zero Exit Time
Selecting this option allow the User to arm the area from
the reader with no exit time.
Part On Arming Allowed
Selecting this option allows the user to arm the area
using their token in Part On and Part 2 On modes. This
funtion is only available at Prox enabled Keypads.
To Arm In All On Mode
From the disarmed state, present the token once to fully
arm the area.
To Arm In Part Mode
Present the token twice within 5 seconds and the area
will arm in Part Mode.
To Arm In Part Mode
Present the token three times within 5 seconds and the
area will arm in Part Mode 2.
Arm If Single User Area
This option allows a roaming reader to turn on only the
rst area that the token user has been assigned to (ie
multi area user). This allows the user to log on when the
token is swiped the second time. Swiping the token a
third time will turn the rst area that the user has been
assigned to All On.
Arm All User Areas
This option allows a token user to turn on or o all areas
that the user has been assign to at the same time. This
option can be set per reader.
» » E N D O F S E C T I O N « «
To Next Page
Loading...
