Bosch Solution 16i - Page 52

5-10
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Access Programming
Access > Prox Reader > L161
Area Assignment

MENU 1-6-1
1 Area 1 Y
2 Area 2 N
3 Area 3 N
4 Area 4 N
This menu programs which area (1 to 4) the reader will
operate. Each reader can assigned to operate a single area.
i
Note
Software version 2.10 and higher now allow
proximity readers to be assigned to multiple areas.
When using a prox keypad reader, if you set the area
assignment to a specic area number then only that area
will arm / disarm when a valid token is used.
If you set the area assignment to 0 (zero), and a token
is presented then the keypad will move to the rst
area which that user has access to. If the same token is
presented a second time then the area currenttly in focus
will arm or disarm.
If the user wants to arm / disarm a dierent area which
they have access to, then after swiping their token the rst
time, they can use the left and right arrow keys to move to
the desired area and then swipe their token a second time
to operate.
If the user wants to arm / disarm all areas they belong to,
then after swiping their token once, they can press and
hold the [ON] key to arm or the [OFF] key to disarm all
areas they belong to.
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [6] + [1] + [OK].
3) Enter the Reader required, then press [OK].
4) Use keys [1] to [4] to toggle on or o the required
area (s), then press [OK] to save and exit or press
[MENU] to exit without saving.
-Bit-
1 2 4
i
Note
The keypad display will return back to its home area
if no keys are pressed or tokens are presented for 60
seconds.
Access > Prox Reader > L162
Access Assignment

MENU 1-6-2
1 Access Group 1 N
2 Access Group 2 N
3 Access Group 3 N
4 Access Group 4 N
5 Access Group 5 N
6 Access Group 6 N
7 Access Group 7 N
8 Access Group 8 N
This menu is used to assign a Prox Reader to one or more
Access Groups (1 to 8). Access Groups are used to restrict
user access to doors.
Setting this option to 0 means the reader will not operate
any system outputs.
1) Entery your Installer PIN + [MENU].
2) Enter [1] + [6] + [2] + [OK].
3) Enter the Reader required, then press [OK].
4) Use keys [1] to [8] to toggle on or o the required
access groups.
-bit-
5) Press [OK] to save and exit or press [MENU] to exit
without saving.
Access > Prox Reader > L163
Reader Options

MENU 1-6-3
1 All On Arming Allowed Y
2 Disarming Allowed Y
3 Badging Required N
4 Zero Exit Time N
5 Part On Arming Allowed N
6 Arm If Single User Area N
7 Reserved N
8 Arm All User Areas N
1) Enter your Installer PIN + [MENU].
2) Enter [1] + [6] + [3] + [OK].
3) Enter the Reader required, then press [OK].
4) Use keys [1] to [8] to toggle on or o the required
reader options.