Bosch Solution 16i - Page 57

6-3
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Area Programming
Areas > Commands > L204
Move To Area

-

MENU 2-0-4
This menu allows you to move the focus of a keypad’s
default home area to a dierent area. Once the keypad’s
focus has changed, you will be able to see the status of
the zones in that area and also perform functions as if you
were using the keypad located or assigned to that area.
This menu allows you to move the focus of a keypad’s
default home area to a dierent area. Once the keypad’s
focus has changed, you will be able to see the status of
the zones in that area and also perform functions as if you
were using the keypad located or assigned to that area.
1) Enter your Installer PIN or Master PIN + [MENU]
2) Enter [2] + [0] + [4] + [OK].
If your system has been congured to have more than
one area, the keypad will display the A = prompt.
A3 OFF
3) Enter the area number (1 to 4) that you want to move
to, then press [OK].
The keypad will now move to the requested area. If
you do not have acces to the selected area the system
will sound a error beep and the keypad focus will
remain un-changed.
The keypad will return to it’s home area, 30 seconds
after the last key press.
i
Note
If the keypad has been programmed to be a roaming
keypad then you can use the [←] and [→] keys to
move between areas at any time.
Areas > Commands > chOnOF
Chime On/O

-

-

-

MENU 2-0-5
Chime mode allows you to monitor a zone (or group of
zones) while the system or area is in the disarmed state.
The system can be programmed to sound the keypad
buzzer or activate a programmable output when the
corresponding chime zone(s) are faulted. This feature can
be useful when you need to monitor the front or back
entrance to the premises.
This menu allows a user to turn chime mode on and o.
Only keypads programmed to sound the chime tone will
be heard when a zone programmed for chime is faulted.
The master user can program which zones are monitored
for chime alarms in MENU 3-0-3.
1) Enter your PIN + [MENU].
2) Enter [2] + [0] + [5] + [OK].
The system will display the current chime state. If your
system has been congured for multiple areas you will
be prompted to enter the area number to program.
In the example below chime mode “ IS OFF”.
iS OFF
3) To turn Chime mode on, simply press the [ON] key.
The display will show that chime mode “IS ON” and
also the chime icon will be displayed.
iS ON
To toggle chime mode o again, simply press [OFF].
4) Press the [OK] key to exit.
i
Note
It is possible to turn chime mode on and o pressing
the 4 key down for 2 seconds. Only the area currently
in focus will operate when using this method.
Areas > Commands > ch typ
Chime Mode

-

MENU 2-0-6
Chime mode allows the master user to control the way
chime alarms operate. There are 4 options available.
1) Chime Always
Will sound the chime alarm while ever the zone(s)
programmed for Chime are open or faulted.
ch ALL
2) Chime One-Shot (Max 255 seconds)
Will sound the chime alarm for the programmed time
regardless of how long the chime zone(s) remains open
or faulted.
ch000