6-2
Bosch Security Systems 09/11 BLCC500I
Solution 16i
Installation Manual Area Programming
The keypad will display the area status information. If
the area is turned All On, the keypad will display:
ALL ON
If the area is turned All O, the keypad will display:
iS OFF
If the area is turned Part On, the keypad will display:
PArt 1
If the area is turned Part 2 On, the keypad will display:
PArt 2
4) To exit, press [OK].
Areas > Commands > L201
Turn Area On/O
-
-
MENU 2-0-1
This menu allows you to turn a single area All On. If your
system has been congured to have multiple areas then
the keypad will prompt you to select the area you wish to
turn All On.
1) Enter your PIN + [MENU].
2) Enter [2] + [0] + [1] + [OK].
If your system has been congured to have more than
one area, the keypad will display the A = prompt.
A=
3) Enter the area number you wish to turn All On, then
press [OK].
Areas > Commands > L202
Turn All Areas On
-
-
MENU 2-0-2
This menu allows you to turn on all areas that your PIN
has been assigned to at the same time All On. The keypad
displays below show the area icons 1 and 2 on indicating
that both Area 1 and Area 2 are armed.
1) Enter your PIN + [MENU]
2) Enter [2] + [0] + [2] + [OK].
The keypad will display the word “LEAVE” in the
display and the exit warning beeper will sound. You
should leave all areas now.
POWER
ON
When exit time has expired, the keypad will display
that the home area (Area 1 in this case) is on, and that
area 2 is also on via the area icons.
POWER
ON
AREA
Area icons will only display if programmed to do so
by your security installer.
Areas > Commands > L203
Turn All Areas O
-
-
MENU 2-0-3
This menu allows you to turn o all areas that your PIN has
been assigned to at the same time. At least one keypad
on the system must be in a diasrmed area before you can
access this command.
1) Enter your PIN + [MENU].
2) Enter [2] + [0] + [3] + [OK].
The system will now disarm all areas that are in the
armed condition provided the user belongs or has
access to the area.
To Next Page
Loading...
