Bosch Solution 16i - Page 92

9-2
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
4) Press [OK] to program telephone number 2.
Ph2 ?
5) Using the numeric keys, enter all of the digits of the
second telephone number (if required).
6) Press [OK] to program telephone number 3.
ph3 ?
7) Using the numeric keys, enter all the digits of the
third telephone number (if required).
8) Press [OK] to save and exit, or press [MENU] to cancel.
i
Note
Domestic reporting must be programmed by your
installer or this location will not be available.
Comms > Commands > cAlAns
Call / Answer RAS

-

-

MENU 5-0-1
This menu allows you to initiate a modem call to the
installer’s o-site computer for programming changes
and updates or to remotely service and congure your
system.
1) Enter your PIN + [MENU].
2) Enter [5] + [0] + [1] + [OK].
Comms > Commands > cfOnOf
Call Forward On/O

-

MENU 5-0-2
This menu allows you to turn on and o the call forward
feature. When you turn on call forwarding, the control
panel will automatically activate and de-activate the call
forward on and call forward o sequence accordingly
when you turn your system All On and O.
For this feature to work you will need to also program the
Call Forward On and Call Forward O Numbers as detailed
later in this section.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [5] + [0] + [2] + [OK].
If call forwarding is o, the keypad will display:
IS OFF
If call forwarding is on, the keypad will display.
IS ON
3) To turn Call Forwarding On, press the [ON] key or
press the [OFF] key to turn call Forwarding o.
4) Press [OK] to exit.
i
Note
See MENU 5-1-6 and MENU 5-1-7 to program the Call
Forward ON and Call Forward OFF number sequence.
Comms > Commands > dircOn
Start Direct Link Session

-

MENU 5-0-5
This menu allows the master user to start a direct link
session without the need for the installer to press and
hold the default button.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [5] + [0] + [5] + [OK].
cOnect
Once the computer and the control panel establishes
a connection, the keypad will automatically return to
the normal state.
Comms > Commands > vOice
Voice Setup

-

MENU 5-0-6
This menu allows the master user to record their own
customised greeting and zone description message that
will be played back to users that are programmed to
receive domestic telephone calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can
then take the appropriate action.
This feature requires an optional voice module to be
tted to the control panel by your installer. Additional
programming information is included with the voice
module.
i
Note
This feature requires rmware version 2.10 or higher.