Bosch Solution 16i - Page 93

9-3
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
P HO NE N UM BE R PR OG R AM MI NG
Comms > Telephone Number > L510
Number Prex

MENU 5-1-0
1 Digits 32
The number prex allows you to program the customer
account number and pass code (PIN) to access the
telephone line exchange when using a pre-paid telephone
account (e.g. Telstra Communic8 Pre-Paid Home account),
or when a number followed by a pause is required to get
an outside line on a PABX system.
The number prex is global for all telephone numbers
programmed in both Destination 1 and Destination 2
(including the domestic telephone numbers and call
forward sequences). the prex will be dialled immediately
before the number.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [1] + [0] + [OK]. The keypad will display
the current Telco Number Prex.
_
3) Using the numeric keys, enter all the digits of the
telephone number prex. You can change a single
digit by scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
Comms > Telephone Number > L511
Primary Dest 1

MENU 5-1-1
1 Digits 32
This menu sets the primary telephone number for Report
Destination 1. This will typically be the primary base
station receiver number.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [1] + [1] + [OK]. The keypad will display
the current Primary Telephone Number for
Destination 1.
_
3) Using the numeric keys, enter all the digits of the
telephone number. You can change a single digit by
scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
Comms > Telephone Number > L512
Secondary Dest 1

MENU 5-1-2
1 Digits 32
This menu sets the secondary telephone number for
Destination 1. This will typically be the secondary base
station receiver number.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [1] + [2] + [OK]. The keypad will display
the current Secondary Telephone Number for
Destination 1.
_
3) Using the numeric keys, enter all the digits of the
telephone number. You can change a single digit by
scrolling the cursor left or right. For special
characters including, pause, * or #, use the up and
down arrow keys.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
Comms > Telephone Number > L513
Primary Dest 2

MENU 5-1-3
1 Digits 32
This menu sets the primary telephone number for Report
Destination 2. This will typically be the primary base
station receiver number.
1) Enter your Installer PIN + [MENU].
2) Enter [5] + [1] + [3] + [OK]. The keypad will display
the current Primary Telephone Number for
Destination 2.
_