Bosch Solution 16i - Page 95

9-5
Bosch Security Systems 09/11 BLCC500I
Solution 16i  Installation Manual  Comms Programming
The default sequence A61PA20H is explained below.
You should modify this sequence to suit your particular
requirements or ask your installer to congure for you.
A61 = (Turn Call Forward On – No Answer).
P = (2 Second Pause).
A20H = (Delay Call Forward sequence for 20 seconds).
3) Using the combination of numeric keys and [↑] and
[↓] keys to program special characters, enter all the
digits of the call forward on sequence.
You can change a single digit by moving the cursor
position using the [←] and [→] keys.
Example:
For the control panel to initiate the sequence
of forwarding all calls immediately to the
telephone number 0212345678, a sequence of
A210212345678H would be programmed.
4) Press [OK] to save and exit, or press [MENU] to exit
without saving.
i
Note
For more information on how to use the Call
Fowarding features contact your telephone service
provider or your installer.
When programming telephone numbers the
following symbols have a special meaning or
function. A = *
H = #
P = Pause (2 second)
Comms > Telephone Number > cfOfPh
Call Forward O

-

MENU 5-1-7
1 Digits 32
# 6 1 #
When you enter your premises, you no longer need to
remember to manually disable the Call Forward feature
via the telephone. This option allows you to program
the Call Forward O sequence that the control panel will
automatically use when you turn Area 1 ‘O’.
In Australia, a typical sequence of activating the Call
Forward O feature is described below:
Call Forward O All Calls -
Immediate
[*][2][1] [#]
or
If No Answer
[*][6][1] [#]
i
Note
For other countries please substitute the appropriate
commands after consultaion with your telephone
company.
1) Enter your Installer PIN or Master PIN + [MENU].
2) Enter [5] + [1] + [7] + [OK].
The keypad will display the current call forward o
sequence.
H61h
The default sequence H61H is explained below. You
should modify this sequence to suit your particular
requirements or ask your installer to congure for you.
H61 (To turn Call Forward With No Answer O).
H (End of Call-Forward sequence)
3) Using the combination of numeric keys and [↑] and
[↓] keys to program special characters, enter all the
digits of the call forward o sequence.
You can change a single digit by moving the cursor
position using the [←] and [→] keys.
For special characters (eg. P = pause, A=* or H=# etc),
use the [↑] and [↓] keys.
4) Press [OK] to save and exit, or press [MENU] to exit
without saving.
CO MM S P R OP ER TIE S
Comms > Properties > L520
Call Attempt Count

MENU 5-2-0
0 6
This menu programs the maximum number of call
attempts the panel will make per destination in order to
deliver the report signal.
At factory default, the maximum number of call attempts
per event is 6 when reporting to a single destination and
12 attempts when reporting to 2 destinations. (6 attempts
per destination)
Domestic dialling also follows the call attempt count.
However, the call attempt count will be spread over total
phone numbers programmed for domestic reporting, ie. if
three domestic telephone numbers are programmed and
the call attempt count is 6, the panel will dial telephone
number 1, telephone number 2 and telephone number 3,
then repeat once giving a total of 6 attempts). if the call is
acknowledged no further calls will be made for that event.
1) Enter your Installer PIN + [ [MENU].
2) Enter [5] + [2] + [0] + [OK]. The keypad will display
the current number of call attempts per
destination. (Default = 6).