Brainchild PR Series - Page 73

Page 73 of 113
Source:
There are two options are available for source. They are as below
 PV
 SV
The first channel will show PV and the second Channel will show SV in source. These
two parameters can be logged in the recorder from the Process Control Card.
 By using the Key to switch between Channels.
Log:
This is to set the desired logging parameter settings
Data Type:
2 byte
2 byte range: -3276.8 to +3276.7
Trigger:
Two options are available
 Disable: Select disable while the recording of a specific channel is not required.
 Enable: Select Enable while the recording of a specific channel is required.
Method:
This is the method of logging measured data. Select Method and Press “Enter”,
soft key to have the selection of different log methods. Then choose the required Log
method. The available log methods are as below.
 Instant: logging the last measured data at the sampling interval
 Average: logging the averaged measured data at the sampling interval
 Minimum: logging the minimum measured data at the sampling interval
 Maximum: logging the maximum measured data at the sampling interval
Speed:
It is the logging speed (recording speed) of measured data. Select Log Speed and
then choose log speed to one of the below.