Braun Aesculap Acculan 4 - Page 19

17
Tool does not attach or
detach.
Incompatible tool Tool does not click into place Use the tool compatible with the attachment.
Tool connector deformed/defec-
tive
Tool is difficult to couple or can-
not be coupled
Use a new tool.
Coupling on attachment
deformed/defective
Tool is difficult to couple or can-
not be coupled
Have the manufacturer repair the attachment.
Tool coupling dirty Tool is difficult to couple or can-
not be coupled
Clean tool or use a new tool.
Clean the attachment.
For GB641R: Kirschner
wire does not insert into
the Kirschner wire chuck
Kirschner wire chuck not set cor-
rectly
Diameter of the Kirschner wire is
not consistent with the scale set-
ting
Set the adjustment sleeve to the right
Kirschner wire diameter.
For GB641R: Kirschner
wire not turning
Kirschner wire chuck not set cor-
rectly
Diameter of the Kirschner wire is
not consistent with the scale set-
ting
Set the adjustment sleeve to the right
Kirschner wire diameter.
Open the clamping lever Open the clamping lever Close the clamping lever.
Clamping lever not pulled back
with sufficient force
Kirschner wire not turning Pull back the clamping lever forcefully and
hold it.
Tool not moving Attachment not fully attached to
the drill
Attachment can be pulled out of
the drill
Correctly attach the attachment and perform a
function test.
Tool not fully attached to the
attachment
Tool can be pulled out of the tool
coupling
Correctly attach the tool and perform a func-
tion test.
Attachment defective Drill turning, but attachment is
not turning.
Have the manufacturer repair the attachment.
Drill defective Drill not turning Have the manufacturer repair the drill.
The safety catch of the drill is in
the OFF position
Safety catch is in OFF position Turn the safety catch into the ON position.
Oil spray adapter not
attachable
Oil spray adapter not compatible Oil spray adapter not attachable Use the compatible oil spray adapter for
GA344.
Issue Cause Detection Remedy