6
Aesculap
®
Acculan 4
Attachments
6.1 System set-up
6.1.1 Connecting the accessories
Combinations of accessories that are not mentioned in the present
instructions for use may only be employed if they are specifically intended
for the respective application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
All configurations must fulfill the fundamental standard
IEC/DIN EN 60601-1. The person connecting the devices with each other
is responsible for the configuration and must ensure that the fundamental
standard IEC/DIN EN 60601-1 or relevant national standards.
► Follow the instructions for use of individual accessories.
► Please address your B. Braun/Aesculap partner or Aesculap Technical
Service with any inquiries in this respect; for a contact address, see
Technical Service.
6.2 Protection against inadvertent activation
The rotational speed control button can be locked to prevent inadvertent
activation of the drill and reamer during a tool/attachment change.
Locking the knob for speed control 2:
► Twist the safety catch 3 to position OFF.
The speed control knob 2 is blocked and the product 1 cannot be oper-
ated.
Unlocking the knob for speed control 2:
► Twist the safety catch 3 to position ON.
The speed control knob 2 is unlocked and the product 1 can be oper-
ated.
Note
For further information on the drill and reamer, see TA014538 or TA014539
(flyer).
6.3 Coupling and uncoupling of attachment to drill
and reamer
► Secure drill and reamer 1 against inadvertent activation with the
safety catch 3, see Protection against inadvertent activation.
Coupling
► Push the attachment onto drill and reamer 1 until it engages with a
click.
► Pull at attachment to check that it is securely coupled.
Uncoupling
► Turn the sleeve 4 in the direction of the arrow 5 and simultaneously
remove the attachment from the drill and reamer 1.
6.4 Attaching and detaching the tool from the
attachment
► Ensure that the tool connector and attachment type are compatible.
6.4.1 Attachments with quick-action chuck GB623R/GB657R/
GB663R/GB664R/GB665R/GB668R/GB669R/GB670R
Coupling
► Pull back on the unlocking sleeve 7.
► Insert the tool shaft in the correct position up to the stop in the tool
holder 8 of the attachment 6/9.
► Release the unlocking sleeve 7.
Tool is attached.
► Pull at tool to check that it is securely coupled.
Uncoupling
► Pull back the unlocking sleeve 7.
► Remove tool.
DANGER
Risk of injury due to unapproved configuration
using additional components!
► Ensure that the classification of all components
used is consistent with the classification of the
product (such as type BF or type CF).
WARNING
Risk of injury when attaching/removing attach-
ments/tools in the ON position through inadvertent
activation of the product!
► Only attach/remove attachments/tools in the
OFF position.
WARNING
Risk of injury when attaching/removing attach-
ments/tools in the ON position through inadvertent
activation of the product!
► Only attach/remove attachments/tools in the
OFF position.
To Next Page
Loading...
