19
12.2 Performance data, information about standards
The product was subject to 500 preparation cycles as a test by the manu-
facturer and has passed.
The performance data for the individual attachments can be found in the
table below.
Drill attachments
Milling attachments
Rotational direction Right and left rotation, oscillation
Conforming to stan-
dard
IEC/DIN EN 60601-1
Attachment Connector Dimensions Length x ∅
[mm] ± 5 %
Weight [g]
±10%
Max. speed [min
-
1
]
Max. torque
[Nm]
Cannula-
tion [mm]
GB620R Jacobs chuck keyless Ø 0.3 mm to
7.4 mm
125 x 35 397 1 000 5 4
GB621R Jacobs chuck with key Ø 0.5 mm
to 7.4 mm
110 x 35 300 1 000 5 4
GB623R AO small 90 x 35 210 1 250 4 4
GB639R Jacobs chuck with key Ø 0.5 mm
to 4.0 mm
105 x 35 243 1 250 4 4
GB645R Synthes radiolucent angle trans-
mission
110 x 35 225 900 5 4
GB663R Trinkle 93 x 35 217 1 000 5 4
GB664R Aesculap hex 86 x 35 225 1 000 5 4
GB665R Hudson/Zimmer 100 x 35 230 1 000 5 4
Attachment Connector Dimensions Length x ∅
[mm] ± 5 %
Weight [g]
±10%
Max. speed [min
-
1
]
Max. torque
[Nm]
Cannula-
tion [mm]
GB657R AO large 108 x 35 300 370 12 4
GB667R Jacobs chuck with key Ø 0.5 mm
to 7.4 mm
133 x 35 280 250 19 4
GB668R AO large 108 x 35 300 250 19 4
GB669R Hudson/Zimmer 118 x 35 300 250 19 4
GB670R Harris 106 x 35 290 250 19 4
To Next Page
Loading...
