Braun Aesculap Acculan 4 - Working with the Device; System Set-up

5
► Keep the instructions for use accessible for the user.
► Always adhere to applicable standards.
► Ensure that the electrical installation of the room is consistent with
the requirements of IEC/DIN EN.
► Do not operate the product in explosion-hazard areas.
► Sterilize product before use.
► When handling, observe instructions for use that are relevant to
Aesculap holder systems TA009721, see Aesculap Extranet at
https://extranet.bbraun.com
4. Product description
4.1 Scope of supply
4.2 Components required for operation
■ Drill and reamer GA330 (ready)
4.3 Operating principle
The attachment can be coupled to the drill and reamer in three different
positions, each offset by 120°.
The attachment locks automatically when attached to the drill and
reamer. The attachment can be removed by operating a rotating sleeve on
the drill and reamer.
The attachments have various integrated couplings on the working end, to
enable attachment of various tools, Kirschner wires or adapters.
5. Preparation
Aesculap assumes no liability if the following rules are not followed:
► Do not use products from open or damaged sterile packaging.
► Prior to use, inspect the product and its accessories for any visible
damage.
► Use the products and their accessories only if they are in perfect tech-
nical condition.
6. Working with the device
Art. no. Designation
GB176R
GB184R
GB620R
GB621R
GB623R
GB628R
GB639R
GB641R
GB645R
GB657R
GB660R
GB663R
GB664R
GB665R
GB667R
GB668R
GB669R
GB670R
XF457R
One of the following attachments/adapters:
Zimmer chuck with Hudson/Zimmer shaft
Harris chuck with AO large shaft
Drill attachment keyless Jacobs chuck
Drill attachment large Jacobs chuck
Drill attachment AO small
Adapter AO large to DHS/DCS step drill
Drill attachment small Jacobs chuck
Kirschner wire attachment
Drill attachment for Synthes radiolucent angle trans-
mission
Medullary reamer attachment AO large
Sagittal saw attachment
Drill attachment Trinkle
Drill attachment Aesculap hexagon
Drill attachment Hudson/Zimmer
Reamer attachment large Jacobs chuck
Reamer attachment AO large
Reamer attachment Hudson/Zimmer
Reamer attachment Harris
DIN chuck with AO large shaft
GA031R Chuck key for large Jacobs chuck (GB620R, GB621R
and GB667R)
GA062R Key for small Jacobs chuck (GB639)
TA014541 Instructions for use for Acculan 4 attachments (flyer)
WARNING
Risk of infection and contamination!
Product is delivered unsterilized!
► Sterilize the product before use pursuant to the
operating instructions.
WARNING
Risk of injury and material damage due to inappro-
priate use of tools!
► Always follow the safety advice and information
given in the instructions for use.
► When coupling/uncoupling, handle tools with
cutting edges with care.
WARNING
Damage to the product if dropped!
► Use the products only if they are in perfect
technical condition, see Function check
WARNING
Risk of burns to skin and tissue through blunt tools
or if product has not been maintained properly!
► Use tools only if they are in perfect condition.
► Replace blunt tools.
► Maintain the product properly, see maintenance
guide.