EasyManua.ls Logo

BridgeTech VB20 - Page 103

BridgeTech VB20
261 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
represented by the bar. This parameter corresponds to the sum of
RTP dups reported by all streams.
RTPooo: Accumulated number of times a packet has been found to be out of
order in the interval represented by the bar. This parameter
corresponds to the sum of RTP ooo reported by all streams.
Tot bitr: Bitrate sensed on the eth0 interface
Mon bitr: Bitrate on eth0 corresponding to joined multicasts
CRC errs: Detected CRC errors. Ethernet CRC errors are most likely caused by
a bad cable or a misconfigured router. A CRC error may impact
packet loss measurements such as CC errors and RTP errors.
Note that the history graphs show the sum for all streams being analysed across all
pages. So for example, if two streams experience No signal at the same time the No
signal graph will increase by 2.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
104

Table of Contents