6.18.5 Data - BOOT
If the Data - BOOT tab is present, this indicates that the probe has an old boot
monitor installed that needs to be upgraded.
The boot monitor is the firmware that controls things like flash memory read/write and
other low level functionality that must be configured before the kernel loads. This has
no direct effect on monitoring features but is an important part of the operating
system.
Click the Upgrade button to start the procedure. The probe will reboot on completion,
and the Data - BOOT tab will no longer be visible in the GUI.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
245
To Next Page
Loading...