BridgeTech VB20 - Redundancy Status and Overview; Redundancy Modes

6.16.4 Redundancy status and overview
Redundancy tab GUI will provide a simple overview of the status on both input signals,
which ETR alarms and redundancy options that is enabled, and which redundancy
mode is enabled.
6.16.5 Redundancy modes
The probe has three different redundancy modes giving the operator different levels of
control. When a physical button is pushed the GUI will be overridden.
Redundancy modes:
SuperLocal: When a physical signal button is pressed on the device
the signal will be switched to the specified signal. The GUI
will also be overridden and set in a SuperLocal
redundancy mode. It is also possible to set the mode to
SuperLocal when in the GUI.
Manual: The operator may alter the output by pressing the GUI
buttons defined in the manual control area. This may also
be done by using 3
rd
party NMS systems.
Auto: The probe itself will determine the output based on the
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00 -
www.bridgetech.tv
217